SIEI Inverter Board XTD9002 TL-EXP-E
Table of Contents
SIEI Inverter Board XTD9002 TL-EXP-E
XIZI TRUST SIEI Inverter Board XTD9002 TL-EXP-E
JG16051800C-193 PG card
Siei EXP-E V5.2 board
Original elevator PG card
TL-EXP-E SIEI inverter AVY feedback PG card
XIZI TRUST SIEI elevator Inverter Board XTD9002 TL-EXP-E
Elevator Spare Parts SIEI Elevator Inverter Welding Pcb Board Inverter PG Card TL-EXP-E V2.2
Ordering the siei inverter board
To order the siei inverter board, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the siei inverter board
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The siei inverter board sits in the control board / PCB group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on siei inverter board come down to electrolytic capacitor ageing, cracked solder joints around the power stage, corroded edge connectors, and blown output transistors after a supply fault.
Every siei inverter board we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the siei inverter board, confirm three things. First, the controller catalogue number and the board revision letter, plus the fault code stored in the controller memory. Second, the same board is frequently fitted across several controller families, so the equipment model alone is not enough to identify the right revision. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: discharge the DC bus before removing a power board, and photograph the connector layout before you unplug anything. Almost every repeat failure we see on siei inverter board traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Bench testing before dispatch catches the majority of faulty stock. Boards are powered up, exercised through their diagnostic modes where the manufacturer supports it, and checked for the specific failure modes that matter in service rather than for cosmetic condition.
Where the root cause is an output stage destroyed by a short in the motor or its cabling, in our experience the board is tested on the bench against the fault mode before it is dispatched.
If you are unsure which variant of the siei inverter board you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same control board / PCB group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because siei inverter board is only one item in the control board / PCB group, these related pages may help you plan the work:
- Elevator spare parts
- Door Operator Controller
- Elevator Display
- Elevator Encoder
- Elevator Service Tool
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
