OTIS Elevator Door Vane SKY H1 AT120 FAA24390H
Table of Contents
OTIS Elevator Door Vane SKY H1 AT120 FAA24390H
Skate, PAX, OTIS AT120, L – 243 mm, right, FAA24390H1
Lift Elevator Spare Parts for Door Skate Vane
OTIS Elevator Door Vane SKY H1 AT120 FAA24390H FAA24390H1
Elevator door vane SKY H1 AT120 Elevator door parts
FAA24390H1 Elevator SKY H1 AT120 Door Vane
This Door Vane have two type, left opening and right opening.
Ordering the otis elevator door
To order the otis elevator door, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the otis elevator door
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The otis elevator door sits in the door system group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on otis elevator door come down to worn door rollers and hanger bearings, stretched operator belts, misaligned door vanes, and light curtain optics that fog up in humid plant rooms.
Every otis elevator door we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the otis elevator door, confirm three things. First, the door operator model, the door width and the number of panels, since a two-panel centre-opening door takes different hardware from a side-opening one. Second, door operators are commonly reused across a product family, so a vane or roller that fits one lift will usually fit its neighbours. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: re-level the track before fitting new rollers, otherwise the new bearings will wear out at the same rate as the old ones. Almost every repeat failure we see on otis elevator door traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Door faults are the single most common complaint on a passenger lift, and the great majority of them trace back to mechanical wear rather than to the controller. Rollers flatten, tracks accumulate grit, and operator belts stretch by a few millimetres — enough to change the door timing and trigger a nuisance fault.
The door is the part of a lift that passengers judge the whole installation by, and the symptom that most often brings an engineer to it is an intermittent reopen with no obstruction present.
If you are unsure which variant of the otis elevator door you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same door system group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because otis elevator door is only one item in the door system group, these related pages may help you plan the work:
- Door operator controllers
- Door Vane
- Elevator Door Guide Shoe
- Elevator Door Hanger Roller
- Elevator Door Operator Belt
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
