OTIS 506 Aluminum STEP
Table of Contents
OTIS 506 Aluminum STEP
OTIS 506 Aluminum STEP
1000MM
STEP ROLLER is Otis roller G0290AJ9
76.2*21.4-6203
Ordering the otis 506 aluminum
To order the otis 506 aluminum, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the otis 506 aluminum
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The otis 506 aluminum sits in the escalator / moving walk group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on otis 506 aluminum come down to worn step rollers and chain elongation, cracked skirt panels, glazed handrail drive wheels, and comb plates with broken teeth after a foreign-object stop.
Every otis 506 aluminum we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the otis 506 aluminum, confirm three things. First, the escalator model, the rise, and whether the unit is a 30 or 35 degree incline, because the step and chain differ between them. Second, a handrail profile that matches the guide rail must be confirmed before ordering, since nominally similar handrails differ in cross-section. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: step chains and handrail drive chains wear as a set — replacing one without the other usually means a repeat visit within the year. Almost every repeat failure we see on otis 506 aluminum traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Safety edges, skirt brushes and comb plates are the parts passengers actually interact with. A broken comb tooth or a missing skirt brush is not merely cosmetic — it is the mechanism that prevents a foot or a shoe from being drawn into the step band.
A unit showing a unit that stops without obstruction and resets without fault is usually telling you that landing plates are lifted on a routine basis to inspect the tension carriage before it runs out of adjustment.
Cleaning the step band is a maintenance task in its own right. Trapped grit between the step and the skirt accelerates wear on both surfaces, and a machine that is cleaned weekly will outlast an identical unit that is cleaned quarterly by a wide margin.
If you are unsure which variant of the otis 506 aluminum you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same escalator / moving walk group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because otis 506 aluminum is only one item in the escalator / moving walk group, these related pages may help you plan the work:
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
Ahmad Kalash
Dear sir
Please send me quotation for No.2 steps 800 mm , OTIS ,
Best regards
[email protected]
Sorry MOQ is 10 pcs