Original PM150RSE120 IGBT
Table of Contents
Original PM150RSE120 IGBT
This Moudle is came from japan and it is 100% new.
Mitsubishi electric in Tokyo made this Mitsubishi IGBT.
All of the world’s Mitsubishi Elevator no matter where the production, all use this IGBT module.
Original PM150RSE120 IGBT
Ordering the original pm150rse120 igbt
To order the original pm150rse120 igbt, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the original pm150rse120 igbt
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The original pm150rse120 igbt sits in the control board / PCB group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on original pm150rse120 igbt come down to electrolytic capacitor ageing, cracked solder joints around the power stage, corroded edge connectors, and blown output transistors after a supply fault.
Every original pm150rse120 igbt we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the original pm150rse120 igbt, confirm three things. First, the controller catalogue number and the board revision letter, plus the fault code stored in the controller memory. Second, the same board is frequently fitted across several controller families, so the equipment model alone is not enough to identify the right revision. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: discharge the DC bus before removing a power board, and photograph the connector layout before you unplug anything. Almost every repeat failure we see on original pm150rse120 igbt traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Bench testing before dispatch catches the majority of faulty stock. Boards are powered up, exercised through their diagnostic modes where the manufacturer supports it, and checked for the specific failure modes that matter in service rather than for cosmetic condition.
Where the root cause is firmware that no longer matches the parameters loaded into the controller, in our experience the board is tested on the bench against the fault mode before it is dispatched.
The power stage is where most board failures originate, and it is usually a symptom rather than a cause. Blown output devices normally follow a motor, cable or supply fault, so replacing the board without finding the underlying problem is a reliable way to destroy the replacement as well.
If you are unsure which variant of the original pm150rse120 igbt you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same control board / PCB group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because original pm150rse120 igbt is only one item in the control board / PCB group, these related pages may help you plan the work:
- Elevator spare parts
- Door Operator Controller
- Elevator Display
- Elevator Encoder
- Elevator Service Tool
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
Sadam hussain
I need quotation for above igbt.
[email protected]
Do you need this type of IGBT PM150RSE120.
And the price has sent to your email.