MTD482 Mitsubishi elevator button
Table of Contents
MTD482 Mitsubishi elevator button
DA482A10G01/G02/G03 Mitsubishi Button
LEHY-2 Mitsubishi Lift button
MTD482 Mitsubishi elevator button
Diameter 35mm
Ordering the mtd482 mitsubishi elevator
To order the mtd482 mitsubishi elevator, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the mtd482 mitsubishi elevator
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The mtd482 mitsubishi elevator sits in the switches / sensors / wiring group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on mtd482 mitsubishi elevator come down to contact pitting, moisture ingress at the cable gland, drifted optical alignment, and brittle insulation on travelling cables after years of flexing.
Every mtd482 mitsubishi elevator we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the mtd482 mitsubishi elevator, confirm three things. First, the switch or sensor model, the mounting pattern, and the supply voltage and contact configuration (NO or NC). Second, contact configuration matters more than physical size — a switch that bolts straight on can still be electrically wrong. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: record the terminal numbers before disconnecting a travelling cable, since colour codes are not consistent between controller generations. Almost every repeat failure we see on mtd482 mitsubishi elevator traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Travelling cables are a special case. They flex on every trip, and the failures happen inside the insulation where they cannot be seen. Replacing a cable that has reached its flex life is cheaper than diagnosing the intermittent faults it will otherwise cause.
A unit showing a levelling error that appears once a week and never on demand is usually telling you that common switches, sensors and relay types are held as stock, because the failure is invisible until it happens.
Displays, buttons and intercoms are passenger-facing, so their failure is immediately visible and often reported before any technical diagnosis is possible. Keeping common faceplates and modules in stock shortens the outage considerably.
The underlying cause is usually an inductive load that has pitted a relay far faster than its rating suggested, which is why the switch or sensor model, the mounting pattern and the contact configuration identify the correct replacement.
Contact ratings matter more than physical fit. A relay that bolts into the same socket as the original can still be wrong for the application if its coil voltage or contact arrangement differs, and the resulting fault will appear somewhere else entirely in the circuit.
If you are unsure which variant of the mtd482 mitsubishi elevator you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same switches / sensors / wiring group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because mtd482 mitsubishi elevator is only one item in the switches / sensors / wiring group, these related pages may help you plan the work:
- Elevator limit switches
- Elevator Levelling Sensor
- Elevator Encoder
- Elevator Push Button
- Elevator Display
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
