KONE TEST TOOL  KM878240G02

Kone KM878240G02 NO TIMES LIMITED
Four-pin connector to RS232 connector

KONE TEST TOOL ENGLISH Version KM878240G02
Item specifics

KM878240G02
Type:Elevator Parts
Place of Origin:Jiangsu China (Mainland)
Brand Name:KONE
Model Number:NO TIMES LIMITED
TIMES LIMITED:NO
SUIT:KONE MAIN NOARD
NET WEIGHT:0.5KGS
Product Description

It can debug all kinds of kone elevator and escalator where the main board has the plug to connect the tool.

There is no time limited.(The old kone tool only can be used for 200 times and than it will be locked.Our kone service tool is not this problem now)
How to use Kone KM878240G02 NO TIMES LIMITED?
1.Began to operate
2.Press button—LED on
3.Hold for few seconds—LED flash
4.Release press–LED off
5.Operate accomplish

Who product Kone KM878240G02 NO TIMES LIMITED?
Wellway electronics LAB

Ordering the kone test tool

To order the kone test tool, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.

About the kone test tool

Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone test tool sits in the general elevator & escalator parts group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone test tool come down to a small number of serviceable assemblies — the controller, the door operator, the brake, the drive chain and the safety circuit.

Every kone test tool we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.

Buying guidance and compatibility notes

Before ordering the kone test tool, confirm three things. First, the equipment model, the controller family and the exact reference printed on the failed component. Second, reference numbers change between revisions, so we map the old code onto the current one before quoting. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.

On fitting, one point is worth repeating: a photograph of the nameplate is usually faster than a description, and avoids a return for the wrong revision. Almost every repeat failure we see on kone test tool traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.

If you are unsure which variant of the kone test tool you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same general elevator & escalator parts group, so a planned shutdown can cover several wear items at once.

Related parts and further reading

Because kone test tool is only one item in the general elevator & escalator parts group, these related pages may help you plan the work:

• Elevator spare parts
• Escalator
• Door Operator Controller
• Elevator Brake Lining
• Handrail Drive Chain

Reference sources

The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.

• ISO 8100-1 — lift and escalator safety standard
• IEC — international electrotechnical standards
• Otis genuine parts reference