kone Speed Limiter

OL35 KONE SPEED GOVERNOR
km80420 KONE Elevator tension wheel 210 260 OL35 Speed governor Tension device
OL35 80420G91L Speed Limiter Elevator Speed Limiter
elevator parts Speed limiter OL35 Tensioner gear Elevator speed limiter

KM973109G03
OSG OL35 CAR,1.60M/S RIGHT STRAIGHT AUTO

KM973124G01
OSG OL35 CAR, 0.63M/S RIGHT, BENT STAND

KM973132G02
OSG OL35 CAR, 1.00M/S LEFT, BENT STAND

KM973105G05
OSG OL35 CAR,1.00M/S RIGHT STRAIGHT AUTO

Ordering the kone speed limiter

To order the kone speed limiter, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.

About the kone speed limiter

Elevator and escalator control systems are built around a relatively small number of serviceable assemblies: the drive and motion controller, the main control or mother board, the power stage, the encoder feedback interface, and the door or brake control module. The kone speed limiter is one of those assemblies, and like every board in the cabinet it is replaced on a different service interval. Each carries its own set of reference numbers depending on the original equipment manufacturer and the revision of the installation.

Every kone speed limiter we supply is inspected before dispatch. Boards are checked for physical damage, capacitor condition and connector integrity, and are packed to survive international transit. Where a superseded revision is the only one available, we state that clearly and explain the substitution so that the installing engineer can make an informed decision.

Buying guidance and compatibility notes

Before ordering the kone speed limiter, confirm three things. First, the exact part number and revision from the failed unit. Second, the equipment model and controller family it was installed in, since the same board can be used across several product lines. Third, whether the installation is a traction lift or an escalator, as the duty cycle and current rating differ between the two.

If you are unsure which revision of the kone speed limiter you need, send a photograph of the nameplate and the existing board alongside the fault description. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable assemblies in the same controller, so that a planned shutdown can cover several wear items at once.

Related parts and further reading

If you are servicing a complete controller, these related pages may help you plan the work:

• Elevator parts catalogue — browse the full range of spare parts we supply.
• Elevator control boards — mother boards, drive boards and power boards.
• Contact our sales team — request a quotation or compatibility check.

Reference sources

The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact part number against your own equipment nameplate.

• ISO 8100-1 lift safety standard — international requirements covering lift components and control systems.
• International Electrotechnical Commission (IEC) — the standards body for electrical equipment used in lift and escalator installations.
• Otis — original equipment manufacturer service and parts reference.