Kone Brake control KM50002114G01
Table of Contents
Kone Brake control KM50002114G01
KONE brake module power board
Kone Brake control KM50002114G01
Outside KM50002114G01, inside board part number KM1376516G01
Can replace the old models KM885513G01 KM885514G01
Ordering the kone brake control
To order the kone brake control, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the kone brake control
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone brake control sits in the brake / safety gear group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone brake control come down to glazed or oil-contaminated linings, weak coils, worn pivot bushes, and spring sets that have lost their rated tension.
Every kone brake control we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the kone brake control, confirm three things. First, the brake model, the drum or disc diameter, and the rated torque shown on the original rating plate. Second, brake units are often shared between a traction machine and its close relatives, but the lining grade can differ with the duty rating. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: brake springs and linings should always be replaced as a matched set, and the air gap re-measured to the manufacturer figure afterwards. Almost every repeat failure we see on kone brake control traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
A brake is a safety device before it is a machine component, and it should be treated that way. Lining thickness, spring tension and air gap all have defined limits, and a brake that is adjusted beyond them may still hold the car while no longer meeting the standard it was certified against.
If the installation is showing a rhythmic noise from the machine that varies with load, the identification route is straightforward: safety gear and overspeed protection are matched to the guide rail and the rated speed, not to the equipment model alone.
Oil contamination is the quiet killer of brake linings. A lining that has absorbed even a small amount of gear oil will lose a disproportionate amount of its friction coefficient, and the symptom — a car that drifts slightly before holding — is easy to miss on a routine service.
The brake is a safety device that happens to be made of machine parts, which is why fasteners are supplied with the assembly where the manufacturer specifies single-use stretch bolts.
If you are unsure which variant of the kone brake control you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same brake / safety gear group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because kone brake control is only one item in the brake / safety gear group, these related pages may help you plan the work:
- Elevator brake linings
- Escalator Brake Lining
- Elevator Limit Switch
- Elevator Load Weighing Device
- Elevator Guide Shoe
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
