Kone 800mm Aluminium alloy step
Table of Contents
Kone 800mm Aluminium alloy step
Kone 800mm Aluminium alloy step.
Ordering the kone 800mm aluminium
To order the kone 800mm aluminium, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the kone 800mm aluminium
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone 800mm aluminium sits in the escalator / moving walk group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone 800mm aluminium come down to worn step rollers and chain elongation, cracked skirt panels, glazed handrail drive wheels, and comb plates with broken teeth after a foreign-object stop.
Every kone 800mm aluminium we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the kone 800mm aluminium, confirm three things. First, the escalator model, the rise, and whether the unit is a 30 or 35 degree incline, because the step and chain differ between them. Second, a handrail profile that matches the guide rail must be confirmed before ordering, since nominally similar handrails differ in cross-section. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: step chains and handrail drive chains wear as a set — replacing one without the other usually means a repeat visit within the year. Almost every repeat failure we see on kone 800mm aluminium traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Safety edges, skirt brushes and comb plates are the parts passengers actually interact with. A broken comb tooth or a missing skirt brush is not merely cosmetic — it is the mechanism that prevents a foot or a shoe from being drawn into the step band.
Escalator maintenance is dominated by the step band and the handrail drive, which is why step chains and handrail drive chains are treated as a set, because replacing one alone usually means a repeat visit within the year.
Balustrade and skirt panels take impact damage that rarely shows until a unit is stopped for inspection. Cracked panels and loose fixings should be logged and replaced before they reach the point of failing a safety inspection.
A unit showing a visible gap opening between the step and the skirt is usually telling you that the handrail profile is confirmed against the guide rail before ordering, since similar rails differ in cross-section.
If you are unsure which variant of the kone 800mm aluminium you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same escalator / moving walk group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because kone 800mm aluminium is only one item in the escalator / moving walk group, these related pages may help you plan the work:
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
