KM606990G01 Replaced by KM606061G05 DRIVE UNIT
Table of Contents
KM606990G01 Replaced by KM606061G05 DRIVE UNIT
KM603810G01 KONE door motor board KONE elevator parts
Replaced by KM606061G10
ELECTRONIC BOX,AMD DRIVE 1.5
Gross weight: 0.754
Component Family Codes
AMD – AMD Advanced Modular Door system
Product Description 
en: ELECTRONIC BOX,AMD DRIVE 1.5
Material Utilisation Group
03177 – DOOR OPERATOR BOARD
Material group
B72 – PCB assembly
Product Family Codes
E-line MonoSpace
KM606990G01
Replaced by KM606061G05
DRIVE UNIT, AMD DRIVE D7
Gross weight: 0,9
KONE elevator pcb board KM606980G01/KM606990G01 KONE parts
Component Family Codes
AMD – AMD Advanced Modular Door system
Product Description
en: DRIVE UNIT, AMD DRIVE D7
Material Utilisation Group
03177 – DOOR OPERATOR BOARD
Material group
B72 – PCB assembly
KM606990G01
KM606980G01
KM606800G01
KM606810G01
KM603810G01
KM603800G01
Ordering the km606990g01 replaced
To order the km606990g01 replaced, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the km606990g01 replaced
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The km606990g01 replaced sits in the control board / PCB group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on km606990g01 replaced come down to electrolytic capacitor ageing, cracked solder joints around the power stage, corroded edge connectors, and blown output transistors after a supply fault.
Every km606990g01 replaced we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the km606990g01 replaced, confirm three things. First, the controller catalogue number and the board revision letter, plus the fault code stored in the controller memory. Second, the same board is frequently fitted across several controller families, so the equipment model alone is not enough to identify the right revision. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: discharge the DC bus before removing a power board, and photograph the connector layout before you unplug anything. Almost every repeat failure we see on km606990g01 replaced traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
If you are unsure which variant of the km606990g01 replaced you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same control board / PCB group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because km606990g01 replaced is only one item in the control board / PCB group, these related pages may help you plan the work:
- Elevator spare parts
- Door Operator Controller
- Elevator Display
- Elevator Encoder
- Elevator Service Tool
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
