Escalator BRAKE COIL
Table of Contents
Escalator BRAKE COIL
BRA450 brake magnet
KM937339 Oneelevator Escalator brake magnet BRA450
BRA450 BRA600 BRA800 BRA1000 BRA1200 escalator brake escalator braking for otis /kone
Elevator brake coil BRA450
Elevator brake TAA330BA1 BRA450 for KONE Gear drive
KM937339
Replaced by KM51772114V000
BRAKE COIL, 230V JIALI
Ordering the escalator brake coil
To order the escalator brake coil, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the escalator brake coil
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The escalator brake coil sits in the brake / safety gear group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on escalator brake coil come down to glazed or oil-contaminated linings, weak coils, worn pivot bushes, and spring sets that have lost their rated tension.
Every escalator brake coil we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the escalator brake coil, confirm three things. First, the brake model, the drum or disc diameter, and the rated torque shown on the original rating plate. Second, brake units are often shared between a traction machine and its close relatives, but the lining grade can differ with the duty rating. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: brake springs and linings should always be replaced as a matched set, and the air gap re-measured to the manufacturer figure afterwards. Almost every repeat failure we see on escalator brake coil traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
If you are unsure which variant of the escalator brake coil you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same brake / safety gear group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because escalator brake coil is only one item in the brake / safety gear group, these related pages may help you plan the work:
- Elevator brake linings
- Escalator Brake Lining
- Elevator Limit Switch
- Elevator Load Weighing Device
- Elevator Guide Shoe
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
