Fujitec Skeleton Wheel
Table of Contents
Fujitec Skeleton Wheel
Fujitec Step Roller 75*23.5-6204
Fujitec Chain Roller 75*23.5-6204
Ordering the fujitec skeleton wheel
To order the fujitec skeleton wheel, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the fujitec skeleton wheel
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The fujitec skeleton wheel sits in the chains / belts / drives group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on fujitec skeleton wheel come down to pitch elongation beyond the wear limit, seized rollers, and sprockets whose tooth profile has hooked after running with a stretched chain.
Every fujitec skeleton wheel we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the fujitec skeleton wheel, confirm three things. First, the chain pitch, link count and the number of strands, since a duplex chain will not substitute for a simplex one. Second, chain numbers are frequently local to a manufacturer, so we match on pitch and link count rather than on the printed number alone. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: always measure elongation across at least twenty pitches — a chain that looks acceptable over five links is often past its limit overall. Almost every repeat failure we see on fujitec skeleton wheel traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Lubrication is a compromise rather than a solution. Too little and the rollers seize; too much and the lubricant collects abrasive dust, which accelerates wear faster than running dry would have done.
A unit showing a tensioner that has reached the end of its adjustment is usually telling you that tension is set with a gauge to the manual figure rather than by feel.
If you are unsure which variant of the fujitec skeleton wheel you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same chains / belts / drives group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because fujitec skeleton wheel is only one item in the chains / belts / drives group, these related pages may help you plan the work:
- Handrail drive chains
- Escalator Main Drive Chain
- Escalator Step Chain
- Step Chain Sprocket
- Step Chain Tensioner
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
