KONE COMB PLATE ESCALATOR 22teeth
Table of Contents
Kone comb plate 200*180
KONE COMB PLATE ESCALATOR 22teeth
Kone ECO ESCALATOR 22 teeth Comb
Ordering the kone comb plate
To order the kone comb plate, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the kone comb plate
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone comb plate sits in the escalator / moving walk group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone comb plate come down to worn step rollers and chain elongation, cracked skirt panels, glazed handrail drive wheels, and comb plates with broken teeth after a foreign-object stop.
Every kone comb plate we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the kone comb plate, confirm three things. First, the escalator model, the rise, and whether the unit is a 30 or 35 degree incline, because the step and chain differ between them. Second, a handrail profile that matches the guide rail must be confirmed before ordering, since nominally similar handrails differ in cross-section. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: step chains and handrail drive chains wear as a set — replacing one without the other usually means a repeat visit within the year. Almost every repeat failure we see on kone comb plate traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Escalators are harder on their components than lifts, simply because they run far more hours. A unit in a transport hub may be in motion eighteen hours a day, which means wear items reach their limits on a schedule measured in months rather than years.
Where the root cause is a comb plate with a broken tooth after a foreign-object stop, in our experience the step band is cleaned as a scheduled task rather than only when a fault appears.
Balustrade and skirt panels take impact damage that rarely shows until a unit is stopped for inspection. Cracked panels and loose fixings should be logged and replaced before they reach the point of failing a safety inspection.
Escalator maintenance is dominated by the step band and the handrail drive; step demarcation borders are replaced far more often than steps, and a worn border is the earliest sign of a step reaching the end of its life.
If you are unsure which variant of the kone comb plate you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same escalator / moving walk group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because kone comb plate is only one item in the escalator / moving walk group, these related pages may help you plan the work:
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
