KONE ID is KM950278G01
Table of Contents
KONE ID is KM950278G01
KM950278G01 Kubler host encoder
KONE ID is KM950278G01
Ordering the kone id
To order the kone id, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the kone id
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone id sits in the general elevator & escalator parts group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone id come down to a small number of serviceable assemblies — the controller, the door operator, the brake, the drive chain and the safety circuit.
Every kone id we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the kone id, confirm three things. First, the equipment model, the controller family and the exact reference printed on the failed component. Second, reference numbers change between revisions, so we map the old code onto the current one before quoting. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: a photograph of the nameplate is usually faster than a description, and avoids a return for the wrong revision. Almost every repeat failure we see on kone id traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Identification is the hard part of any legacy order. Reference numbers change between revisions, the same assembly is sold under different codes in different markets, and the marking on a failed part is often the least reliable piece of information available.
The parts that are hardest to find are usually the ones that fail most often; lead time is often the deciding factor rather than price, once the cost of a second visit is counted.
Packaging and handling decide whether a part arrives fit to fit. Electrostatic damage, humidity and mechanical shock are avoidable, and the cost of doing it properly is trivial against the cost of a second outage.
From a spares point of view, identification is done against the equipment record and the failed part together rather than against either alone; warranty terms are a useful proxy for how thoroughly a part was tested before dispatch.
If you are unsure which variant of the kone id you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same general elevator & escalator parts group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because kone id is only one item in the general elevator & escalator parts group, these related pages may help you plan the work:
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
