Kone LCE OPT Borad PCB
Table of Contents
LCE OPT Borad
Kone KM713150G01,
Kone KM713153H04,
LCE OPT Borad.
Ordering the lce opt borad
To order the lce opt borad, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the lce opt borad
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The lce opt borad sits in the control board / PCB group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on lce opt borad come down to electrolytic capacitor ageing, cracked solder joints around the power stage, corroded edge connectors, and blown output transistors after a supply fault.
Every lce opt borad we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the lce opt borad, confirm three things. First, the controller catalogue number and the board revision letter, plus the fault code stored in the controller memory. Second, the same board is frequently fitted across several controller families, so the equipment model alone is not enough to identify the right revision. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: discharge the DC bus before removing a power board, and photograph the connector layout before you unplug anything. Almost every repeat failure we see on lce opt borad traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
The practical difficulty with legacy boards is that the original manufacturer may have revised the design three or four times without changing the order code. A board that looks identical to the one you removed can be electrically different, and fitting the wrong revision is a common cause of repeat faults.
Drive and logic electronics sit at the centre of every modern installation. The underlying cause is often firmware that no longer matches the parameters loaded into the controller.
Anti-static handling is not a formality. A board that works perfectly on the bench can be destroyed by a discharge too small for a technician to feel, which is why stock travels in shielded bags and is unpacked only at the point of fitting.
If the installation is showing a drive that trips on acceleration but runs normally at low speed, the identification route is straightforward: knowing whether the installation is machine-room or machine-room-less narrows the controller family immediately.
Firmware is the hidden variable. Two boards with the same part number can carry different firmware revisions, and a replacement that is electrically correct may still need a parameter download before the lift will run properly. Where we know this applies, we say so before shipping.
If you are unsure which variant of the lce opt borad you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same control board / PCB group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because lce opt borad is only one item in the control board / PCB group, these related pages may help you plan the work:
- Elevator spare parts
- Door Operator Controller
- Elevator Display
- Elevator Encoder
- Elevator Service Tool
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
