MITSUBISHI Stainless steel STEP
Table of Contents
MITSUBISHI Stainless steel STEP 1000MM
Ordering the mitsubishi stainless steel
To order the mitsubishi stainless steel, send the exact model or reference code printed on the original part to [email protected]. Please quote the full code including any suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the mitsubishi stainless steel
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The mitsubishi stainless steel sits in the escalator / moving walk group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on mitsubishi stainless steel come down to worn step rollers and chain elongation, cracked skirt panels, glazed handrail drive wheels, and comb plates with broken teeth after a foreign-object stop.
Every mitsubishi stainless steel we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the mitsubishi stainless steel, confirm three things. First, the escalator model, the rise, and whether the unit is a 30 or 35 degree incline, because the step and chain differ between them. Second, a handrail profile that matches the guide rail must be confirmed before ordering, since nominally similar handrails differ in cross-section. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: step chains and handrail drive chains wear as a set — replacing one without the other usually means a repeat visit within the year. Almost every repeat failure we see on mitsubishi stainless steel traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Newel rollers and the handrail entry guide are small parts with a large influence on how a unit feels. A worn newel roller produces a rhythmic knock that passengers notice immediately, and a misaligned inlet chews the handrail from the inside where the damage cannot be seen.
The underlying cause is usually a tension carriage that has run out of adjustment range, which is why a thirty-degree unit takes different steps and chains from a thirty-five-degree unit of the same manufacturer.
If you are unsure which variant of the mitsubishi stainless steel you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same escalator / moving walk group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because mitsubishi stainless steel is only one item in the escalator / moving walk group, these related pages may help you plan the work:
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
