KONE KM713150G01 LCE OPT BOARD
Table of Contents
KONE KM713150G01 LCE OPT BOARD
KM713150G01 LCE OPT BOARD
KONE Part Number:
KM713150G01
Description:
BOARD,OPTION REPLACES KM713150G11
Ordering the kone km713150g01 lce
To order the kone km713150g01 lce, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.
About the kone km713150g01 lce
Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone km713150g01 lce sits in the control board / PCB group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone km713150g01 lce come down to electrolytic capacitor ageing, cracked solder joints around the power stage, corroded edge connectors, and blown output transistors after a supply fault.
Every kone km713150g01 lce we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.
Buying guidance and compatibility notes
Before ordering the kone km713150g01 lce, confirm three things. First, the controller catalogue number and the board revision letter, plus the fault code stored in the controller memory. Second, the same board is frequently fitted across several controller families, so the equipment model alone is not enough to identify the right revision. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.
On fitting, one point is worth repeating: discharge the DC bus before removing a power board, and photograph the connector layout before you unplug anything. Almost every repeat failure we see on kone km713150g01 lce traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.
Bench testing before dispatch catches the majority of faulty stock. Boards are powered up, exercised through their diagnostic modes where the manufacturer supports it, and checked for the specific failure modes that matter in service rather than for cosmetic condition.
When a customer reports an intermittent stop at a random floor with no repeatable pattern, our first question is about aging electrolytic capacitors that have lost capacitance rather than failed outright rather than about the electronics.
If you are unsure which variant of the kone km713150g01 lce you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same control board / PCB group, so a planned shutdown can cover several wear items at once.
Related parts and further reading
Because kone km713150g01 lce is only one item in the control board / PCB group, these related pages may help you plan the work:
- Elevator spare parts
- Door Operator Controller
- Elevator Display
- Elevator Encoder
- Elevator Service Tool
Reference sources
The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.
louie guarascio
How much for one and how long to ship. Thank you and have a pleasant evening
[email protected]
have send you email