KONE NMX11 traction machine

Nmx11 km51015154v000-cmx is USD 5580/pc
The price is for a 100% new Nmx11
Directly sent from Kunshan KONE China,
Special Safety Goods, SN number must be accurate.
7-14 days delivery time,
Export packaging, about 0.5CBM, 400KG.

We can also sale Stator coil machine only.
MX10 STATOR COIL is Distributed winding stator coils.
NMX11 STATOR COIL is Centralized winding stator coils.

Ordering the kone nmx11 traction

To order the kone nmx11 traction, send us a photograph of the existing unit and its nameplate at [email protected]. Please quote the complete code including any revision suffix so that our team can confirm the correct variant, current stock and lead time before you commit.

About the kone nmx11 traction

Elevator and escalator installations are built around a relatively small number of serviceable assemblies, but they fail at very different rates. The kone nmx11 traction sits in the brake / safety gear group, and it is replaced on a different service interval from the assemblies around it. In practice the failures we see on kone nmx11 traction come down to glazed or oil-contaminated linings, weak coils, worn pivot bushes, and spring sets that have lost their rated tension.

Every kone nmx11 traction we supply is inspected before dispatch. Each unit is checked for physical damage, correct marking and the specific wear or degradation patterns that matter for this class of component, then packed to survive international transit. Where a superseded revision is the only one available, we say so plainly and explain the substitution, so the installing engineer can make an informed decision rather than discovering the difference on site.

Buying guidance and compatibility notes

Before ordering the kone nmx11 traction, confirm three things. First, the brake model, the drum or disc diameter, and the rated torque shown on the original rating plate. Second, brake units are often shared between a traction machine and its close relatives, but the lining grade can differ with the duty rating. Third, whether the installation is a traction lift or an escalator, since duty cycle and loading differ between the two.

On fitting, one point is worth repeating: brake springs and linings should always be replaced as a matched set, and the air gap re-measured to the manufacturer figure afterwards. Almost every repeat failure we see on kone nmx11 traction traces back to a related component that was left in place, or to an adjustment that was assumed rather than measured.

If you are unsure which variant of the kone nmx11 traction you need, send a photograph of the nameplate and the existing component alongside a description of the fault. That is usually enough for our team to identify the correct replacement without a site visit, and it avoids the cost and delay of returning an incompatible part. We are also happy to advise on the other serviceable items in the same brake / safety gear group, so a planned shutdown can cover several wear items at once.

Related parts and further reading

Because kone nmx11 traction is only one item in the brake / safety gear group, these related pages may help you plan the work:

• Elevator brake linings
• Escalator Brake Lining
• Elevator Limit Switch
• Elevator Load Weighing Device
• Elevator Guide Shoe

Reference sources

The compatibility information on this page was cross-checked against the following authoritative references. Always confirm the exact reference against your own equipment nameplate.

• ISO 8100-1 — lift safety standard
• Otis genuine brake & safety components
• Schindler brake systems